Harley Davidson Heated Grips Installation Instructions

I know this works 100 percent as i have internally wired about 10 pairs now.

Harley davidson heated grips installation instructions. Left and right hand grips and installation instructions WARRANTY. The instructions for the grips say Not to be used on internally wired handlebars Being from Wyandotte County Kansas I intend to ignore this. It appears that once you remove the grip the wires are there in the handlebar and just need to be connected and new grip installed.

NOTE Make sure that the handlebar surface is smooth dry and thor-oughly cleaned of all dirt. Does the connector extend past the opposite end of the handlebar. Repeat on the other side of the cap.

Remove the Brake perch assembly Switch Housing and Right Grip from the Handlebar according to the service-manual instructions and move aside or leave hanging. How-To Install Harley Heated Grips. I even internally wired Harleys heated grips that are designed to be ran externally by notching the grip.

Dont forget to plug the twist grip sensor back in if you have not already. Grips have been thermally mapped to provide a more-uniform heat and are designed to achieve a maximum operating temperature approximately 20. The following installation instructions cover the Heater Installation Controller Installation Power and Electrical Connections and the Grip Replacements.

Combine style and comfort for cool morning or frigid night rides. The easiest most accessible way to power the heated grips is with the open accessory wires that are typically accessible near the headlamp plug. Determine if the extension is required for this installation.

Mark on the throttle sleeve where the external wires should be. Reassemble the right side hand grip switch housing and front master cylinder. Twist Grip Sensor Installation Instructions Heated Grip Instructions Contact Us Store policies.