Harley Davidson Exhaust Nut Torque

516 - 19 ft. Do initial loosening and final tightening while on side stand. Torque to 10 -12ft lbs ft.

harley davidson bike cleaner harley davidson bike images hd harley davidson bike models in india harley davidson bike names harley davidson bike on sale harley davidson bedding australia harley davidson bike dryer harley davidson bike insurance uk

Torque Specs For Exhaust Studs Harley Davidson Forums

Exhaust Header Torque Settings Harley Davidson Forums

Black Loose Cannon Slip On Muffler Brand Firebrand Year Make Model 2015 2017 Harley Davidson Harley Davidson Pictures Harley Davidson India Harley Exhaust

2016 Harley Davidson Street Glide Torque Specs

04 Dyna Engine Install Torque Specs Harley Davidson Forums

Harley-davidson Torque Spec Chart.

Harley davidson exhaust nut torque. Additionally tighten the head pipe support bracket bolts as indicated in the exhaust manufacturers instructions. Repeat on the rear cylinder. HARLEY -DAVIDSON Manufacturer Part Number.

If you are referring to the cylinder head exhaust flange --- tighten the top nut of the front head to 9-18 in-lbs then tighten the lower nut to 120 in-lbs finally tighten the top nut to 120 in-lbs. Torque spec is 140 to 150 ftlbs 190 to 203 Nm. They act like a heat sink and also cover ALL the threads so taking off your exhaust is easier and less chance of wrecking the threads or breaking an exhaust stud BAD JU UJ.

Tighten the cylinder head flange nuts to the torque specifications listed in the Service Manual. Dyna Sportster Softail Touring. 38 - 33 ft.

65184-02 7593. The torque PROCEDURE requires you tighten the top nut to 9-18 INCH pounds and then final torque the bottom nut and then final tourqe the top nut. Rear axle nut and left side axle hex are 36 mm.

Fastener Size - Torque ft. 18Install the heat shields starting with the rear pipe first then the front pipe and then the collector heat shield. Id suggest removing mufflers first and getting the Service Manual 99501-08.

Remove the used HO2S gasket from sensor and install a new gasket to the HO2S gasket sold separately. Retain exhaust flanges and mounting hardware for later installation. Thank you for the inquiry.