Harley Davidson Exhaust Gasket Installation Tool

If necessary re-tighten the hardware.

Harley davidson exhaust gasket installation tool. Reconnect the flange connection after replacing the system on hangers if applicable with new hardware nuts bolts washers and lock washers. Start the vehicle and check the flange connection for leaks. Ad Fast Free Shipping on Orders Over 40.

Made from aluminum thread that is woven into a mesh the gaskets deform upon compression by the exhaust pipe and flange. Install the washer and nut on each cylinder heat stud. Clean the exhaust ports.

With the bracket removed and clamp loosened remove the crossover pipe using a twisting motion. Tool made from a high performance urethane elastomer that exhibits ultra-high tear and impact properties. Expert Gear Advice From Riders.

Harley Davidson Exhaust Gasket. Tool has a tensile strength of 11850 PSI. This tool is designed to install Harley Davidson twin cam exhaust gaskets part 17048-98 square type.

Has a 38 square hole to accept a 38 extension to be used as a handle. Works with exhaust flange nuts or JIMS handle PART NO. The trick is knowing what to look for.

Using a 58 socket or wrench loosen the exhaust clamp. Remove the old exhaust crush gaskets. Some front pipe gaskets are called donut gaskets and fit into a ball-flared exhaust pipe.