Harley Davidson Exhaust Flange Nut Torque

First you should pre-load the.

Harley davidson exhaust flange nut torque. I bought a new nut and checked the Sportster manual for the correct torque for the flange nuts and it says tighten to 96-120 in lbs. Tighten the exhaust flange nuts evenly and to a torque of 60-80 inlbs. Additionally tighten the head pipe support bracket bolts as indicated in the exhaust manufacturers instructions.

097-109 mm Spark plug torque - 12-18 ft-lbs 16-24 Nm Oiling System. Dyna Sportster Softail Touring. Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary.

14 - 10 ft. Remove the two bolts from each muffler body where they attach to the mounting bar. Tighten the cylinder head exhaust flange nut.

The nfieldgear catalog says the correct torque is 4 ftlbs 48 inlbs. Harley Davidson Master. Assuming your using new gaskets you might want to repeat a second time.

The torque values I found for that size thread gives 8 ftlbs for a steel to steel interface. Expert Gear Advice From Riders. Spark plug type Harley-Davidson - 6R12 Spark plug gap - 0038-0043 in.

Ad Fast Free Shipping on Orders Over 40. For model frame code install the megaphone mounting bracket 676-P with grommet to the megaphone with two 516 flange bolts and dog bone nut plate supplied. Tighten lower nuts to 60-80 in.