Harley Davidson Exhaust Bolt Torque
Discussion Starter 1 Mar 6 2008.
Harley davidson exhaust bolt torque. Then remove the rear exhaust pipe mounting bolts. Sustained engine speed - 5500 rpm. Ad Fast Free Shipping on Orders Over 40.
I always check the torque values after everything is bolted up too. Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary. 3 Tighten each bolt to 22-25 foot pounds of torque.
This might be a bit high but because it is a steel stud in an aluminum head it could serve as a guide to a maximum limit. My service manual says to use NEW torx screws to remount the front brake disc rotors and tighten 16 to 24 FOOT lbs. Torque the muffler support bolts to 19 foot.
Tighten each bolt to 7-9 foot pounds of torque. You may have to remove the heat shields in order to access the bolts on all the flanges and use antiseize compound all that heat and corrosion will make things tough the next time. I would tighten the TORCA clamps to 45-60 ft-lbs.
Joined Nov 6 2006 523 Posts. Tighten the exhaust flange nuts evenly and to a torque of 60-80 inlbs. Step 6 Raise the exhaust pipes back up and thread the head bolts and rear mounting bolts into position.
Minton explains that the procedure requires the use of a torque wrench but not for final tightening. 10 - 22 in. Youll now want to lower the exhaust pipes until you see the exhaust pipe opening on your Harley-Davidson motorcycle.